Replies: 2 comments 5 replies
-
|
Can you provide a picture of the board? |
Beta Was this translation helpful? Give feedback.
-
|
|
Beta Was this translation helpful? Give feedback.
-
|
It's not xingzhi-cube series. And I don't think it's an open-source board. |
Beta Was this translation helpful? Give feedback.
-
|
You can check the real board name in the serial console log or xiaozhi.me web console. Just like this: #1296 |
Beta Was this translation helpful? Give feedback.
-
|
thank @78 for your feedback. |
Beta Was this translation helpful? Give feedback.
-
|
Hi, I have found the model of my board using just like @78 suggested. I looked the name from the web console and found out it was zuowei-c3-lcd. I managed to email the manufacturer at ai@zuoweitech.cn to get the firmware. They sent me a link to upload the firmware using web based firware uploader. It took me about 4 tries. I am not sure why the earlier upload didnt work but it said it was successfully uploaded. after the forth upload, the screen lights up and it was okay. Now it is working but unfortunately I couldnt change the interface language as it is not open source. Thank you all for the reply. |
Beta Was this translation helpful? Give feedback.
-
i have the same issue, can you help me? |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
-
I have a board with esp32 c3 with 8mb flash and 1.54 lcd. It has 3 buttons and one sliding on off switch. The outer case is similar to xingzhi-cube but it is not esp32 s3. I tried all the firmware with no success. It was advertised as esp32 s3 but when I checked the chip carefully, it is esp32 c3. I tried downloading all the firmware and also compiling with espressif IDF with no success.
Beta Was this translation helpful? Give feedback.
All reactions