报错了。。。。

[lssb]

Your wifi AP configure:

• AP:
  • SSID: 3
  • PASSWROD: 12312312
  • WAN: eth0
  • LAN: wlan0
• DHCP:
  • ROUTER: 192.168.43.1
  • RANGE: 192.168.43.2 - 192.168.43.10
  • DNS: 119.29.29.29, 8.8.8.8
• SS RELAY: no

Please Confirm your configure, Enter to continue, Ctrl-C to exit.

===== Creating WiFi AP... =====

dnsmasq: no process found
hostapd: no process found
net.ipv4.ip_forward = 1
Configuration file: hostapd.conf
Failed to create interface mon.wlan0: -95 (Operation not supported)
wlan0: Could not connect to kernel driver
Using interface wlan0 with hwaddr b8:27:eb:c8:01:39 and ssid "3"
Failed to set beacon parameters
wlan0: Could not connect to kernel driver
Interface initialization failed
wlan0: interface state UNINITIALIZED->DISABLED
wlan0: AP-DISABLED
wlan0: Unable to setup interface.
hostapd_free_hapd_data: Interface wlan0 wasn't started

WiFi Stop, Cleaning......

hostapd: no process found
net.ipv4.ip_forward = 0

Done!

rpi3 的板子，，，，，

[lssb]

如果是直接用create_ap的话是可以的

pi@raspberrypi:~/create_ap $ sudo create_ap wlan0 eth0 3 33333333
WARN: brmfmac driver doesn't work properly with virtual interfaces and
it can cause kernel panic. For this reason we disallow virtual
interfaces for your adapter.
For more info: oblique/create_ap#203
WARN: Your adapter does not fully support AP virtual interface, enabling --no-virt
Config dir: /tmp/create_ap.wlan0.conf.Ts8HdQQn
PID: 1475
Network Manager found, set wlan0 as unmanaged device... DONE
Sharing Internet using method: nat
hostapd command-line interface: hostapd_cli -p /tmp/create_ap.wlan0.conf.Ts8HdQQn/hostapd_ctrl
Configuration file: /tmp/create_ap.wlan0.conf.Ts8HdQQn/hostapd.conf
Failed to create interface mon.wlan0: -95 (Operation not supported)
wlan0: Could not connect to kernel driver
Using interface wlan0 with hwaddr b8:27:eb:c8:01:39 and ssid "3"
wlan0: interface state UNINITIALIZED->ENABLED
wlan0: AP-ENABLED