erm, what is the URL to view this in my browser?

[therealrobster]

Hi all,

I've checked the linux terminal output, viewed tickets, scoured code. Read the instructions md but can find nowhere that has caught my eye to show me the url to load?

EG: localhost://5001 or similar?

May I please ask what the URL is to run this after terminal says Model loaded in 17.0s (load weights from disk: 3.1s, create model: 0.7s, apply weights to model: 9.1s, hijack: 0.1s, load textual inversion embeddings: 0.3s, calculate empty prompt: 3.5s).

Thanks so much!

[Nem-z]

By default it's 127.0.0.1:7860 but if you don't see it in the console you might have an issue.

Screenshot on my console (on Windows but it should look similar on Linux I guess):

[Soulreaver90]

Its the same on Linux, it's just always not obvious to spot since its hidden among the wall of text. Might be great if the font can be colored or maybe have it stand out more obvious. I personally have it set to autolaunch, but I guess you would still need the IP if you are going to run it over mobile or something.

[Nem-z]

I agree that a bit of color could help non tech savvy people to see the informations better.
The coloring of the console output is possible since it's the case with SD.Next for instance.

[Woisek]

So none of you are aware that this link stays always the same? 🤔
I mean, it's not that you connect to a different address every time ... just bookmark it and it's good ...

[Nem-z]

It never changed since I started using SD in January 2023.

[Soulreaver90]

I don't see at any point either Nem or I stating that we didn't? Not sure where you got that assumption from. Also it's still good to know where to check as you'll get an additional URL if you activate public sharing. Plus the original poster may have a legitimate issue where the IP isn't stated on the console, which would be a problem for new users.

[w-e-w]

if you're running webui locally then it should open in browser automatically unless you turn it off
#12254

by default webui will use http://127.0.0.1:7860 by default
however if this point is already used then it will try the next port 7861 and so on

you can choose a port yourself by using --port 12345
if a Port is specified then it will always use that port
if that Port is in use by some other application it will fail to launch

this can be useful depending on what you're doing