A summary of the missing information required to re-produce this work

[85256638]

Thanks a lot for your dedication to open-source this great piece of work. After thoroughly review the readme, I summarised a list of missing information which required to re-produce this work:

1. Exact model number of the sliping Slip Ring and 24V Battery #15
   
   Senring sales team were unable to work out the model used.

2. BOM of the PCB board.
   
   i.e. the capacitor, crystal oscalliator used in this project etc.

3. Mounting structures for Livox Lidars. LiDAR-lMU-Motor central mounting structure for Livox Lidars. #14

4. Information about the red IMU board used for Hesai and Velodyne Lidar
   

5. STM32 source code stm32 source code #9

6. what is the purpose of this little red button?
   

[jxx315]

The hollow shaft of this motor has an inner diameter of 18mm, Slip Rings with 22mm OD cannot be adapted.

[jxx315]

me either are looking for the right control panel bom!

Slip Rings with 22mm OD cannot be adapted.

[jxx315]

as i understood outer diameter is 22mm

The inner diameter of the motor is 18mm, the outer diameter is 22mm, the outer diameter of the slip ring is 22mm, how to insert it?

[himhan34]

i think i had given the wrong information so I erased all, after checking the right information I will comment.