GITBOOK text correction of the drop-downs example.

Author: petrasvestartas

gitbook/examples/basic-design/drop-downs.md

@@ -16,7 +16,7 @@ layout:
 
 <figure><img src="../../.gitbook/assets/examples_dropdowns.png" alt=""><figcaption></figcaption></figure>
 
-Frei Otto designed lightweight shell-like forms that feature "drop-down" elements. These drop-down features are extensions of the shell that descend toward the ground, acting like inverted columns. Instead of traditional columns supporting the shell from below, these hanging forms help distribute loads efficiently while maintaining the fluid, natural aesthetic typical of Otto’s work. They create a balance between tensile and compressive forces, often seen in his pneumatic and membrane structures.
+Frei Otto designed lightweight shell-like forms that feature "drop-down" elements. These drop-down features are extensions of the shell that descend toward the ground, acting like inverted columns. Instead of traditional columns supporting the shell from below, these hanging forms help distribute loads efficiently while maintaining the fluid, natural aesthetic typical of Otto’s work. They create a balance between tensile and compressive forces, often seen in his pneumatic and membrane structures. In this example, we will set boundary points to facilitate a smooth transition between boundary support and point supports.
 
 {% file src="../../.gitbook/assets/examples_dropdowns.3dm" %}
 
@@ -38,7 +38,7 @@ Create a pattern from a mesh. You can start with the attached Rhino file or a se
 
 **Command:** `RV_pattern_supports` > `Add`> `Manual`> `Select Vertices`
 
-Manually set the boundary points on the top and bottom edges of the mesh.
+Manually set the boundary for the full outer ring of the mesh a few points inside the hole.
 
 <figure><img src="../../.gitbook/assets/examples_dropdowns_1.png" alt=""><figcaption></figcaption></figure>
 
@@ -86,7 +86,7 @@ Leave default parameters as is to reach the horizontal equilibrium. Since horizo
 
 **Command:** `RV_tna_vertical` > `1.5`
 
-The final geometry is computed by running the vertical equilibrium command, change the height to 2 to match the preview. For preview, we use the following options:`RV_settings > Drawing > show_pipes` and `show_forces`.
+The final geometry is computed by running the vertical equilibrium command, change the height to match the preview. For preview, we use the following options:`RV_settings > Drawing > show_pipes` and `show_forces`.
 
 <figure><img src="../../.gitbook/assets/examples_dropdowns_5.png" alt=""><figcaption></figcaption></figure>