BlueSCSI Toolbox

[VitaliyYakob]

BlueSCSI v2 (Pico2) with Wi-Fi is connected to ATTO SiliconExpress IV on Quadra 950 with an UltraSCSI cable via a 68-pin - > 50-pin adapter.
BlueSCSI Toolbox applications cannot find BlueSCSI (v1.0.2 or 1.1.0b1), giving an error that the device is not found.

Debuglog.txt does not contain useful information, even after starting the debug application

In Main!
SCSISelect - id: 6 err: 2
SCSISelect - id: 5 err: 2
SCSISelect - id: 4 err: 2
SCSISelect - id: 2 err: 2
SCSISelect - id: 1 err: 2
SCSISelect - id: 0 err: 2

Wi-Fi doesn't work too.
I will also attach the BlueSCSI log with the debug enabled.
log.txt

Without changing anything, I decided to connect another BlueSCSI v2 DB25.
Wi-Fi worked right away.
SD Transfer v1.0.2 started, showed a window and immediately fell into a MacsBug error, to save it I used "stdlog all"

StdLog.txt

SD Transfer v1.1.0b1 seems to work fine, but shows an extended directory only from DB25.

CD Changer didn't start anywhere, because it can't find BS.

Then I connected BSv2 with a 50-pin cable, the situation has not changed: Toolbox and Wifi do not work.
Is it a bug?

[erichelgeson]

Please attach the ini you're using (sans password if in it)

Was the DB25 that worked connected the ATTO card?

[VitaliyYakob]

Wi-Fi without a password.
DB25 connects to the SCSI port on the Q950 motherboard.

That is, if the BS connects to the ATTO card 68 or 50-pin, then Wi-Fi and Toolbox cannot find BS.

I can connect the BS directly to the motherboard with a 50-pin cable, but I'm sure it will work right away. :)

[erichelgeson]

I do not see the ini file, did you attach it?

I do not have an ATTO card, is there a non-apple driver you used with it? It seems macos toolbox is unable to do a select to devices on that bus for some reason.

[VitaliyYakob]

My ini file is minimal

[SCSI]
#Same effect as DIPSW2, enables verbose log messages
#Debug = 1 # On

#Wi-Fi settings
WiFiSSID = "Old-Mac-Net"

#Optionally look for image files in subdirectory
#Multiple directories can be specified Dir1...Dir9
Dir1 = "/HDs"
Dir2 = "/DEVs"

[SCSI3]
#Reinsert any ejected CD-ROM image on Inquiry command, 1 to enable, default off.
ReinsertCDOnInquiry = 1

There are no special extensions or control panel elements. Apparently, everything you need is already in the firmware of this board. It just works right away. I have a set of utilities found here. According to the documentation, you just need to add the application to Startup and that's it.

If you can tell me how to carry out the diagnostics, I can do everything necessary.