Program problems of ESPI Library in stm32f103c8t6

[CJT1111]

Hello, friend
My problem is that the ESPI library is applied to STM32 Series MCU. First, I did an experiment (Application of ESPI on esp32). This experiment perfectly displayed the content. But ask
The question appeared in the ESPI library and STM32. I modified the user_ Setup。 The pin definition of the. H file (other definitions I tested in esp32 are normal), as shown in the figure:

But de reported this fault. As shown in the figure:

The above is only one of the questions. When I continue to experiment, I find that esp32 does not have port multiplexing function? However, when I repeatedly define data and clock on the SPI port used by the SD card
The display will not be available. However, this problem does not matter, because I can solve the problem by avoiding several ports used by the SD card. I look forward to the answer from the great God.

[Bodmer]

I do not get the same errors. Make sure you have the correct board package loaded into the Arduino IDE and not an old deprecated version. I have version 2.3.0:

[CJT1111]

Sorry, I'm not using the official stm32dino library, but a third-party library, because the third-party library is optimized for F1. I think the performance of this library is better than the official library.

[Bodmer]

It appears the board package is therefore not compatible with the library. I am unable to help with that.

[CJT1111]

Well, thank you for your reply. I'm looking for other ways