Wavsehare ESP32-S3 1.69" Touch Help with Wired Switch

[aaronthorp]

Hi all,

I ordered a 1.69" ESP device which should have the GPIO patch cable however I was sent the touch version that just has GPIO exposed on the bottom of the board, the issue is that it doesn't expose GPIO16 on that header only 2,3,17 & 18.

Save for downloading all the tools and re-compiling with footswitch 1 and 2 set to GPIO 2 and 3 instead of 2 and 16, is there any other way it can be setup to work before I head down that path?

[aaronthorp]

Ended up recompiling with GPIO 2/3 for footswitch 1/2 and works perfectly

[Builty]

Thats a tough one for me. I might be able to eventually change the Web config to allow selection of IO pins, but for now the approach you used is probably the best one.