Waveshare ESP 32-S3 1.69" Display touch version

[DdMan1301]

Hello everyone! I bought the Waveshare ESP 32-S3 1.69" Display touch version, it uses 11 contacts and not 12, as in the version without a touch screen, so the footswitch does not work correctly for me, it only works forward, it does not switch presets back. As far as I know, someone modified the firmware for this model. If you share, I will be very grateful!!!

[DdMan1301]

Or tell me what I can change in the firmware myself to work correctly, I will learn if necessary! Thanks!

[Builty]

I'll give you a build in a few hours

[Builty]

Beta build for the 1.69" Touch is available now.

[DdMan1301]

Thanks for the new firmware with official support for 1.69 touch. I tested V1.0.7.2_beta_6, unfortunately it is still very unstable, spontaneous reboots occur, even without connecting a footswitch, channels switch independently back and forth. The footswitch is also unstable, one step forward or backward - then a reboot. Switching through the web version and through M-Vave Choclolat works stably, but reboots also continue. I tried connecting through different valid pins and different connection voltages from 100 mA to 500 mA. The result is that the firmware is not stable yet. On firmware V1.0.7.2_beta_5 the device works stably without reboots, the only problem is with the footswitch. Ready to test new firmware if you continue to work on supporting the 1.69 touch device! Thank you!

[Builty]

Thanks for the feedback. I don't have a touch to test this on, but I did find a bug in the footswitch pin allocation.
Could you please try this one attached.
The allocations for the footswitches are:
Footswitch 1: GPIO 3
Footswitch 2: GPIO 2
Footswitch 3: GPIO 44 (UART RX)
Footswitch 4: not supported due to lack of IO. Set to GPIO44 also.

TonexOneController_V1.0.7.2_beta_7_Waveshare_1_69_Touch.zip

[DdMan1301]

Great job! Now switching presets works correctly and the firmware is stable, I will check it with long-term use, but so far there have been no reboots. I have a footswitch with two buttons, it works perfectly on pins GPIO 2 and GPIO 3. When I tried to replace one pin with GPIO 44 (UART RX) - it did not have an effect with different combinations, maybe this is because the footswitch has only 2 buttons. But on GPIO 2 and GPIO 3 everything works fine! Wow! Cool! You're a great guy!

[Builty]

Awesome.
I think I can finally get 1.0.7 out of beta, and start on the next version.

[DdMan1301]

Yes, this is great, the functionality of your program - the web version and the possibilities of external control are simply unprecedented!!!