Validating if source and target External networks have same subnets | list index out of range

[kerub77]

Hi,
Tool version: 1.4.2.2
NSX-V: 6.4.14.20609341
NSX-T: 4.1.2.0.0.22589037

In case of external network direct attached to the edge.
If on vCloud the external network is missing with suffix -v2t, the tool fails with this error:
Validating if source and target External networks have same subnets | list index out of range

Using the prvious tool version the error is correct:
Validating if source and target External networks have same subnets | All the Source External Networks Subnets are not present in Target External Network - t0 for edgeGateway gw1-External_TEST.; External network Fake_External is used by edge Gateway - gw1-External_TEST. It's equivalent NSX-T segment backed external network - Fake_External-v2t is not present | Failed

[luizspinheiro]

Hello,
I had this same error, I created the nsx-t segment as an external network in vcloud and I get the same error as this post
#6
because it tries to create the NAT, but the tool is not configuring the same IP that is on the NSX-V Edge
I'm stuck on this
Im using Tool version 1.4.2 and NSX-T 4.1.2.5