Skip to content

Troubleshooting

Jump to bottom
Yijiang Huang edited this page Oct 30, 2020 · 4 revisions

The Capture component cannot export data and/or snapshots

This problem can be fixed by doing the following two simple steps:

  1. In your Rhino's command line, type GrasshopperDeveloperSettings

  2. Check the  “Memory load *.GHA assemblies using COFF byte arrays” box and then restart Rhino. You should be good to go!

Then, don't forget to restart Rhino after changing the setting. 

Further debugging tips:

  1. You DO need to create a save folder if that folder does not exist beforehand!
  2. Don't forget to right-click on the "Mode" parameter of Capture and select "Save Both" to save both the CSV data and snapshots!

the MOO component is not working

If your MOO component in DSE is not working properly, please make sure that you install the necessary extra dependencies that are not shipped with DSE (because of a software licensing conflict). Below is simply a snapshot of the MOO section in DSE's readme, which you can find in the DSE folder after you unzip it.

Clone this wiki locally