Cooling mode #13
Replies: 3 comments 6 replies
-
|
Dip switch must also be set on the heat pump main board to allow cooling |
Beta Was this translation helpful? Give feedback.
-
|
|
Beta Was this translation helpful? Give feedback.
-
|
Shows flow rate is on 19lpm so is active with the water pumps too |
Beta Was this translation helpful? Give feedback.
-
|
What does system operation show on the main controller? |
Beta Was this translation helpful? Give feedback.
-
|
Off |
Beta Was this translation helpful? Give feedback.
-
On main controller? It's dip switch 2-4 you need to set ON for cooling |
Beta Was this translation helpful? Give feedback.
-
|
|
Beta Was this translation helpful? Give feedback.
-
|
Just noticed i. That zone heat is on lol my bad it's both coolings a tick now |
Beta Was this translation helpful? Give feedback.
-
|
Seems it understood turning them switches to cooling flow rate showing it on 19lpm but card still displaying as idle so it maybe a fault my end somewhere |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
-
Anyone else with the cooling feature it just get stuck on idle on thermostat card [
Beta Was this translation helpful? Give feedback.
All reactions