JLCPCB file errors

[btuysser]

Hi Sahas,

I really like how well this project is documented. I tried to follow the instructions at https://www.findmycat.io/docs/CircuitBoard/JLCPcbManufacturing

and I'm getting the following errors after uploading BOM&CPL :

BATT designator don't exist in the BOM file.
RST1,RST2 designators don't exist in the CPL file.

Do they need to be updated?

[akbaruddink]

+1

[codersx]

+1

[LukeShu]

From Slack:

Transcription:

mppem:

@chitlangesahas My understanding from the schematics is that these designators are terminals to attach the battery and a jumper to perform a reset - and as such do not need/have components attached to them. Please would you confirm that for me?

screenshot of JLCPCB reading:

Error
The below parts won't be assembled due to data missing.
BATT designator don't exist in the BOM file.
RST1,RST2 designators don't exist in the CPL file.
[Re-upload file] [Continue]

chitlangesahas:

That is correct! Safe to ignore

mppem:

Thank you!!

[rozgonyiadam]

If it's safe to ignore, then just to confirm: several components are shown as "No Part Selected" during the JLCPCB PCBA order process:

• DWM3001C1 (Qorvo module)
• JP1 to JP8 (solder jumpers)
• Possible test points or footprints marked NC (e.g. L2, Z4-Z6)
• U1, U2, Z1 (show "shortfall" errors – out of stock)

What would be the recommended substitutes or selections for these parts, if any?
Or are they intended to be hand-soldered after delivery?

[leebobleebob]

Same as @rozgonyiadam

[leebobleebob]