Can't find the good IP

[Orangina-L]

Hello,

Thank you for your job !

I have an ECU R installed by a professional in RJ45.
EMA APP works great,

I tried to install your integration with the IP of the ECU R that I found in my local network, but It didn't work, if I try to copy the ip in firefox, it also doesn't work.

I tried to do what you explain in the readme with EMA Manager but for the point 5, the app didn't find the wifi network...... (or my inverters, pictures enclosed).

Do you know what is the problem? is it because an installer configured my system and it wasn't me that it doesn't work?

Other question ECU R could be connected in the same time with RJ45 and WIFI ?

Thank you a lot in advance !

Thomas

[HAEdwin]

Hi Thomas, for the ECU manager App you'll have to activate the AP on the ECU. Hold the button on the ECU for three seconds and the hotspot will be activated. You than will be able to connect with your mobile phone's WiFi. SSID should start with ECU_R (incl. ECU ID). Connect to it (make sure automatically connect to your regular SSID it switched off). The ECU manager app can now be used to configure the WiFi (connect to your local SSID WiFi). But it depends on which ECU-ID you have. If you have the ECU-R (2160 series) and ECU-B then you really have to use WiFi else you could use wired. Note that each connection (WiFi, Ethernet) uses it's own IP-address so make absolutely shure you have the right IP-address. Yes, you can use both at the same time but it depends on the model if port 8899 is open on the ECU.