Changing the GPIO pin used for shutdown

[coolman1987us]

I'm only interested in using this to shutdown and I cant seem to figure out where to find the file to edit the GPIO pin used. I would like to use GPIO23 (pin 16 on Pi B+). Thanks in advance.

[mptrs]

Not sure if you solved it, but you can change the listen-for-shutdown.py line 9 and 10. I think changing the 3 into 23 should do the trick.

GPIO.setup(23, GPIO.IN, pull_up_down=GPIO.PUD_UP)
GPIO.wait_for_edge(23, GPIO.FALLING)

[coolman1987us]

I did end up finding it. Thank you.