-
Notifications
You must be signed in to change notification settings - Fork 2
Razorbill RP100 Strain Cell PSU
Wiki > The Backend System > Specific Device IOC > Power Supplies > Razorbill RP100
This is a small power supply (±200V, ±6mA) used to drive a piezoelectric strain cell. It has a USB interface which connects to an AnywhereUSB USB<->Ethernet adapter on the beamline, or a local PC for testing/setup.
WISH are the primary users of this device and previously have had to borrow one from SE Electronics Group, but now have their own unit.
The VI sent a "Clear Status" command on startup (*CLS) but this contravenes IBEX code not to alter a device's state on starting an IOC, therefore the command was not implemented. However, it would be very simple to add this should the need arise.
The PSU has a short list of remote commands as it's a very simple device to control. The IOC implements most of these:
- ID String
- Read & write voltage
- Read & write voltage slew rate (ramp rate)
- Read & write output (On / Off state)
It is also possible to read the instantaneous voltage and current present at the front panel terminals, but this was not required for the initial creation of the IOC.
A simple OPI exists to interact with the IOC.