[Bug] RGB effects when switching to BT

[joseamirandavelez]

Describe the Bug

When I switch to BT (a second computer) while still connected to USB, the keyboard switches to the internal RGB animation. But since it is still connected to the USB cable it also receives the signal from SignalRGB and starts to flicker until I disconnect the cable. Is it possible to modify the firmware so that if a signal is received via USB it uses that instead of turning on the internal animation?

514681474-6fa71919-d0b1-460c-8310-938ca6863ae2.mp4

Keyboard Used

keyboards/keychron/q5/ansi

Link to product page (if applicable)

No response

Operating System

Windows 11

qmk doctor Output

Is AutoHotKey / Karabiner installed

• AutoHotKey (Windows)
• Karabiner (macOS)

Other keyboard-related software installed

No response

Additional Context

No response

[Tymon3310]

well, if im right, to make kb work with signalrgb you need a custom firmware, correct? if yes, make an issue here: https://github.com/SRGBmods/QMK-Binaries

[PeterMortensen]

Re "make an issue ... SRGBmods": Yes, agreed.

It doesn't seem like something Keychron should be concerned about.

Though details/analysis of why it happens could still be interesting.

[PeterMortensen]

But SRGBmods refused. It is disappointing they didn't even analyse the problem. It could be something simple that was overlooked in the SignalRGB part.

The solution ought to be almost trivial. Checking the connection mode is not that complicated. The SignalRGB project ought to offer more than absolute nada, e.g., some information, say, the location where a condition can be added.

I have added it to the wishlist (numero 71).