Zennismart ZM85EL-2Z reset to re-pair, end-stops are lost

[Drizzt321]

I have some Zennismart ZM85EL-2Z curtain rod motors, and I had them working under ZHA. I've re-built my Home-Assistant, and switched to using Z2M. Unfortunately, as part of the repairing, the settings that I had gotten set for the open/close end stops via the remote when I first set them up are gone. Is there any way via Z2M to set those states? Or do I need to dig out a remote I know I kept (somewhere!) and do it all over again?

[Drizzt321]

Ok, well, nevermind. Apparently via the Dashboard device box, the Border, I can set Down/Up to indicate the correct position (after I do open/close, then stop at the right spot). Very neat!