[Feature Request] Push fit / crush tabs (no glue) in magnet holes

[ilium007]

Firstly, thanks for the project!

Would it be possible to get push fit / crush tabs in the magnet holes and chamfer options like the version in https://gridfinity.perplexinglabs.com / Gridfinity Refined project?

This is the OpenSCAD code that generates the "wave" around the circle:

/**
 * @brief A circle with crush ribs to give a tighter press fit.
 * @details Extrude and use as a negative modifier.
 *          Idea based on Slant3D's video at 5:20 https://youtu.be/Bd7Yyn61XWQ?t=320
 *          Implementaiton is completely different.
 *          Important: Lower ribs numbers just result in a deformed circle.
 * @param outer_radius Final outer radius.
 * @param inner_radius Final inner radius.
 * @param ribs Number of crush ribs the circle has.
**/
module ribbed_circle(outer_radius, inner_radius, ribs) {
    assert(outer_radius > 0, "outer_radius must be positive");
    assert(inner_radius > 0, "inner_radius must be positive");
    assert(ribs > 0, "ribs must be positive");
    assert(outer_radius > inner_radius, "outer_radius must be larger than inner_radius");

    wave_range = (outer_radius - inner_radius) / 2;
    wave_vertical_offset = inner_radius + wave_range;
    fragments=get_fragments_from_r(wave_vertical_offset);
    degrees_per_fragment = 360/fragments;

    // Circe with a wave wrapped around it
    wrapped_circle = [ for (i = [0:degrees_per_fragment:360])
        [sin(i), cos(i)] * wave_function(i, ribs, wave_range, wave_vertical_offset)
    ];

    polygon(wrapped_circle);
}

/**
 * @brief A cylinder with crush ribs to give a tighter press fit.
 * @details To be used as the negative for a hole.
 * @see ribbed_circle
 * @param outer_radius Outer Radius of the crush ribs.
 * @param inner_radius Inner Radius of the crush ribs.
 * @param height Cylinder's height.
 * @param ribs Number of crush ribs.
 */
module ribbed_cylinder(outer_radius, inner_radius, height, ribs) {
    assert(height > 0, "height must be positive");
    linear_extrude(height)
    ribbed_circle(
        outer_radius,
        inner_radius,
        ribs
    );