correct link

Author: halkazwini

articles/virtual-wan/virtual-wan-faq.md

@@ -355,7 +355,7 @@ The current behavior is to prefer the ExpressRoute circuit path over hub-to-hub
 
 For new deployments, this connectivity is blocked by default. To allow this connectivity, you can enable these [ExpressRoute gateway toggles](virtual-wan-expressroute-portal.md#enable-or-disable-vnet-to-virtual-wan-traffic-over-expressroute) in the "Edit virtual hub" blade and "Virtual network gateway" blade in Portal. However, it is recommended to keep these toggles disabled and instead [create a Virtual Network connection](howto-connect-vnet-hub.md) to directly connect standalone VNets to a Virtual WAN hub. Afterwards, VNet to VNet traffic will traverse through the Virtual WAN hub router, which offers better performance than the ExpressRoute path. The ExpressRoute path includes the ExpressRoute gateway, which has lower bandwidth limits than the hub router, as well as the Microsoft Enterprise Edge routers/MSEE, which is an extra hop in the datapath.
 
-In the diagram below, both toggles need to be enabled to allow connectivity between the standalone VNet 4 and the VNets directly connected to hub 2 (VNet 2 and VNet 3): **Allow traffic from remote Virtual WAN networks** for the virtual network gateway and **Allow traffic from non Virtual WAN networks** for the virtual hub's ExpressRoute gateway. If an Azure Route Server is deployed in standalone VNet 4, and the Route Server has [branch-to-branch](../route-server/configure-route-server#configure-route-exchange) enabled, then connectivity will be blocked between VNet 1 and standalone VNet 4. 
+In the diagram below, both toggles need to be enabled to allow connectivity between the standalone VNet 4 and the VNets directly connected to hub 2 (VNet 2 and VNet 3): **Allow traffic from remote Virtual WAN networks** for the virtual network gateway and **Allow traffic from non Virtual WAN networks** for the virtual hub's ExpressRoute gateway. If an Azure Route Server is deployed in standalone VNet 4, and the Route Server has [branch-to-branch](../route-server/configure-route-server.md#configure-route-exchange) enabled, then connectivity will be blocked between VNet 1 and standalone VNet 4. 
 
 Enabling or disabling the toggle will only affect the following traffic flow: traffic flowing between the Virtual WAN hub and standalone VNet(s) via the ExpressRoute circuit. Enabling or disabling the toggle will **not** incur downtime for all other traffic flows (Ex: on-premises site to spoke VNet 2 won't be impacted, VNet 2 to VNet 3 won't be impacted, etc.).