Merge pull request #213537 from mcevoy-building7/medtech-deploy-nav

new navigation

Author: prmerger-automator[bot]

articles/healthcare-apis/iot/deploy-03-new-manual.md

@@ -86,15 +86,15 @@ There are three ways to deploy FHIR service:
 
 After you have deployed FHIR service, it will be ready to receive the data processed by MedTech and persist it as a FHIR service Observation.
 
-## Continue on to Configuration
+## Continue on to Part 2: Configuration
 
-After your prerequisites are successfully completed, you can go on to [Part 2: Configuration](deploy-05-new-config.md).
+After your prerequisites are successfully completed, you can go on to Part 2: Configuration. See **Next steps** below.
 
 ## Next steps
 
-In this article, you learned about the prerequisites needed to deploy the MedTech service manually. When you are ready to begin Part 2 of Manual Deployment, see
+When you are ready to begin Part 2 of Manual Deployment, see
 
 >[!div class="nextstepaction"]
->[Configure the MedTech service for manual deployment using the Azure portal](deploy-05-new-config.md)
+>[Part 2: Configure the MedTech service for manual deployment using the Azure portal](deploy-05-new-config.md)
 
 FHIR® is a registered trademark of Health Level Seven International, registered in the U.S. Trademark Office and is used with their permission.

articles/healthcare-apis/iot/deploy-05-new-config.md

@@ -190,15 +190,15 @@ Your validation screen should look something like this:
 
 If your MedTech service didn't validate, review the validation failure message, and troubleshoot the issue. Check all properties under each MedTech service tab that you've configured. Go back and try again.
 
-## Continue on to Deployment and Post-deployment
+## Continue on to Part 3: Deployment and Post-deployment
 
-After your configuration is successfully completed, you can go on to [Part 3: Deployment and post deployment](deploy-06-new-deploy.md).
+After your configuration is successfully completed, you can go on to Part 3: Deployment and post deployment. See **Next steps** below.
 
 ## Next steps
 
-In this article, you were shown how to configure MedTech service in preparation for deployment and ensure that everything has been validated. When you are ready to begin Part 3 of Manual Deployment, see
+When you are ready to begin Part 3 of Manual Deployment, see
 
 >[!div class="nextstepaction"]
->[Manual deployment and post-deployment of MedTech service](deploy-06-new-deploy.md)
+>[Part 3: Manual deployment and post-deployment of MedTech service](deploy-06-new-deploy.md)
 
 FHIR® is a registered trademark of Health Level Seven International, registered in the U.S. Trademark Office and is used with their permission.