G5 Sensor change failed

[bionictom]

Hi, my G5 sensor was due to change and I did. It stopped working after. After the warm-up I was asked for calibration, which I entered, and it showed me the BG value. Since then, there's nothing.System Status says: "Got data" and there's nothing in the logs.

One strange thing is that Transmitter resistance jumped up. It was something like 800 a couple of hours ago, now its 1140.

Today in the morning I got the little popup that says.... got 1/3 readings, next reading expected in...... and it only got to 2 readings and nothing more after that.

[Navid200]

Do I understand correctly that you are using the native mode but but have Fallback to xDrip enabled?
Would you mins showing a snapshot of the following page?
Settings -> G5/G6 Debug Settings

[bionictom]

I'm not using native mode, Fallback is greyed out but ticked.

[Navid200]

Are any of the settings different than these?
Never mind the grayed out ones.

https://github.com/Navid200/xDrip/wiki/G5-Recommended-Settings

[Navid200]

What version of xDrip is this?
You can see on the first line on classic status page.

[bionictom]

I updated a few days ago:
cc96742-2021.06.19
code:2106191119

I did the stop and am now restarting. I'm gonna report if something is working/not working

[Navid200]

Something went wrong when you entered your initial calibrations. I am not 100% sure why.
The restart should hopefully sort it out.

[bionictom]

Thanks, it is working now.

[Navid200]

Fantastic