SBUS pin on FSI6X? #193
Replies: 1 comment 13 replies
-
|
It's not implemented currently as no one of us have SBUS module. This functionality is waiting for volunteers. |
Beta Was this translation helpful? Give feedback.
-
|
Check those RX and TX pins on unpopulated module on the right side of PCB. Don't know which of the gpios are connected. You may want to try to figure it out with multimeter and then check in datasheet what is possible on those pins. |
Beta Was this translation helpful? Give feedback.
-
|
@ajjjjjjjj / @FRPProject : did you make progress on implementing serial communication with an external RF module? If not, what are your current conclusions (which serial pin to use, ...)? |
Beta Was this translation helpful? Give feedback.
-
|
No I didn't make much progress, I decided to get ELRS module. |
Beta Was this translation helpful? Give feedback.
-
|
@dgehriger you can use any serial available on the board, maybe reuse TX2 pad - same as CRSF. |
Beta Was this translation helpful? Give feedback.
-
|
@ajjjjjjjj Thanks! Just to clear up some confusion on my side: the multi protocol module doesn't expose a full serial (rx/tx) but a "smart serial" using half duplex? Correct ? |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
-
Do you know which is the pin that outputs SBUS on FSI6X? is it PA9? I am trying to use SBUS pin on the FSI6X board for my external module. Thank you.
Beta Was this translation helpful? Give feedback.
All reactions