AMD RX 9070 XT Hellhound - how to deal with 0 RPM mode

[godzinilla]

Hi,
The Hellhound has the following 0 RPM mode: when the temperature rises to 50 degrees, the fans start working at minimal speed (30%). However, to enter the 0 RPM mode, the temperature needs to drop to 30 degrees. Between 30 and 50 degrees, the fans run at 30% speed.

How do I set this behaviour in FanControl? Should I use the trigger option and set it to a range of 30–50 degrees with 0%/30% RPMs? Then should I use the regular curve from the 50-degree point with 30% speed up to the maximum desired temperature/speed?

[godzinilla]

Did I set it correctly? Looks like this is working as expected:

The graph is set from 50 degree point with 30% speed. Below the 50 degree point the speed is set to 0 %.

[Rem0o]

Yep this replicate the behavior exactly as you described with the trigger, assuming the graph is aligned also.

[godzinilla]

Thank you!