usb: ucsi_acpi: Increase the command completion timeout

Commit 130a96d ("usb: typec: ucsi: acpi: Increase command
completion timeout value") increased the timeout from 5 seconds
to 60 seconds due to issues related to alternate mode discovery.

After the alternate mode discovery switch to polled mode
the timeout was reduced, but instead of being set back to
5 seconds it was reduced to 1 second.

This is causing problems when using a Lenovo ThinkPad X1 yoga gen7
connected over Type-C to a LG 27UL850-W (charging DP over Type-C).

When the monitor is already connected at boot the following error
is logged: "PPM init failed (-110)", /sys/class/typec is empty and
on unplugging the NULL pointer deref fixed earlier in this series
happens.

When the monitor is connected after boot the following error
is logged instead: "GET_CONNECTOR_STATUS failed (-110)".

Setting the timeout back to 5 seconds fixes both cases.

Fixes: e080650 ("usb: typec: ucsi: acpi: Reduce the command completion timeout")
Cc: [email protected]
Reviewed-by: Heikki Krogerus <[email protected]>
Signed-off-by: Hans de Goede <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Greg Kroah-Hartman <[email protected]>

Author: jwrdegoede

drivers/usb/typec/ucsi/ucsi_acpi.c

@@ -78,7 +78,7 @@ static int ucsi_acpi_sync_write(struct ucsi *ucsi, unsigned int offset,
 	if (ret)
 		goto out_clear_bit;
 
-	if (!wait_for_completion_timeout(&ua->complete, HZ))
+	if (!wait_for_completion_timeout(&ua->complete, 5 * HZ))
 		ret = -ETIMEDOUT;
 
 out_clear_bit: