clk: tegra: Fix initial rate for pll_a on Tegra124

pll_a_out0 and the I2S clocks are already configured to default to rates
corresponding to a 44.1 kHz sampling rate, but the pll_a configuration
was set to a default that is not listed in the frequency table, which
caused the PLL code to compute an invalid configuration. As a result of
this invalid configuration, Jetson TK1 fails to resume from suspend.

This used to get papered over because the ASoC driver would force audio
clocks to a 44.1 kHz configuration on boot. However, that's not really
necessary and was hence removed in commit ff5d18c ("ASoC: tegra:
Enable audio mclk during tegra_asoc_utils_init()").

Fix the initial rate for pll_a so that it matches the 44.1 kHz entry in
the pll_a frequency table.

Fixes: ff5d18c ("ASoC: tegra: Enable audio mclk during tegra_asoc_utils_init()")
Signed-off-by: Thierry Reding <[email protected]>
Link: https://lkml.kernel.org/r/[email protected]
Signed-off-by: Stephen Boyd <[email protected]>

Author: thierryreding

drivers/clk/tegra/clk-tegra124.c

@@ -1292,7 +1292,7 @@ static struct tegra_clk_init_table common_init_table[] __initdata = {
 	{ TEGRA124_CLK_UARTB, TEGRA124_CLK_PLL_P, 408000000, 0 },
 	{ TEGRA124_CLK_UARTC, TEGRA124_CLK_PLL_P, 408000000, 0 },
 	{ TEGRA124_CLK_UARTD, TEGRA124_CLK_PLL_P, 408000000, 0 },
-	{ TEGRA124_CLK_PLL_A, TEGRA124_CLK_CLK_MAX, 564480000, 0 },
+	{ TEGRA124_CLK_PLL_A, TEGRA124_CLK_CLK_MAX, 282240000, 0 },
 	{ TEGRA124_CLK_PLL_A_OUT0, TEGRA124_CLK_CLK_MAX, 11289600, 0 },
 	{ TEGRA124_CLK_I2S0, TEGRA124_CLK_PLL_A_OUT0, 11289600, 0 },
 	{ TEGRA124_CLK_I2S1, TEGRA124_CLK_PLL_A_OUT0, 11289600, 0 },