iavf: fix the waiting time for initial reset

Every time I create VFs on ice, I receive at least one "Device is still
in reset (-16), retrying" message per VF. It recovers fine, but typical
usecases should not trigger scary-looking messages.

The waiting for reset is too short. It makes no sense to check every 10
microseconds. Typical reset waiting times are at least tens of
milliseconds and can be several seconds. I suspect the polling interval
was meant to be 10 milliseconds all along.

IAVF_RESET_WAIT_COMPLETE_COUNT is defined as 2000, so the total waiting
time could be over 20 seconds. I have seen resets take 5 seconds (with
128 VFs on ice).

The added benefit of not triggering the "Device is still in reset" path
is that we avoid going through the __IAVF_INIT_FAILED state, which would
take a full second before retrying.

Signed-off-by: Michal Schmidt <[email protected]>
Reviewed-by: Wojciech Drewek <[email protected]>
Tested-by: Rafal Romanowski <[email protected]>
Signed-off-by: Jacob Keller <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Jakub Kicinski <[email protected]>

Author: michich

drivers/net/ethernet/intel/iavf/iavf_main.c

@@ -4786,7 +4786,7 @@ static int iavf_check_reset_complete(struct iavf_hw *hw)
 		if ((rstat == VIRTCHNL_VFR_VFACTIVE) ||
 		    (rstat == VIRTCHNL_VFR_COMPLETED))
 			return 0;
-		usleep_range(10, 20);
+		msleep(IAVF_RESET_WAIT_MS);
 	}
 	return -EBUSY;
 }