net: ethernet: mtk_eth_soc: reset PCS state

Reset the internal PCS state machine when changing interface mode.
This prevents confusing the state machine when changing interface
modes, e.g. from SGMII to 2500Base-X or vice-versa.

Fixes: 7e53837 ("net: ethernet: mediatek: Re-add support SGMII")
Reviewed-by: Russell King (Oracle) <[email protected]>
Tested-by: Bjørn Mork <[email protected]>
Signed-off-by: Daniel Golle <[email protected]>
Signed-off-by: David S. Miller <[email protected]>

Author: dangowrt

drivers/net/ethernet/mediatek/mtk_eth_soc.h

@@ -542,6 +542,10 @@
 #define SGMII_SEND_AN_ERROR_EN		BIT(11)
 #define SGMII_IF_MODE_MASK		GENMASK(5, 1)
 
+/* Register to reset SGMII design */
+#define SGMII_RESERVED_0	0x34
+#define SGMII_SW_RESET		BIT(0)
+
 /* Register to set SGMII speed, ANA RG_ Control Signals III*/
 #define SGMSYS_ANA_RG_CS3	0x2028
 #define RG_PHY_SPEED_MASK	(BIT(2) | BIT(3))

drivers/net/ethernet/mediatek/mtk_sgmii.c

@@ -88,6 +88,10 @@ static int mtk_pcs_config(struct phylink_pcs *pcs, unsigned int mode,
 		regmap_update_bits(mpcs->regmap, SGMSYS_QPHY_PWR_STATE_CTRL,
 				   SGMII_PHYA_PWD, SGMII_PHYA_PWD);
 
+		/* Reset SGMII PCS state */
+		regmap_update_bits(mpcs->regmap, SGMII_RESERVED_0,
+				   SGMII_SW_RESET, SGMII_SW_RESET);
+
 		if (interface == PHY_INTERFACE_MODE_2500BASEX)
 			rgc3 = RG_PHY_SPEED_3_125G;
 		else