You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
drm/i915/cdclk: Fix voltage_level programming edge case
Currently we only consider the relationship of the
old and new CDCLK frequencies when determining whether
to do the repgramming from intel_set_cdclk_pre_plane_update()
or intel_set_cdclk_post_plane_update().
It is technically possible to have a situation where the
CDCLK frequency is decreasing, but the voltage_level is
increasing due a DDI port. In this case we should bump
the voltage level already in intel_set_cdclk_pre_plane_update()
(so that the voltage_level will have been increased by the
time the port gets enabled), while leaving the CDCLK frequency
unchanged (as active planes/etc. may still depend on it).
We can then reduce the CDCLK frequency to its final value
from intel_set_cdclk_post_plane_update().
In order to handle that correctly we shall construct a
suitable amalgam of the old and new cdclk states in
intel_set_cdclk_pre_plane_update().
And we can simply call intel_set_cdclk() unconditionally
in both places as it will not do anything if nothing actually
changes vs. the current hw state.
v2: Handle cdclk_state->disable_pipes
v3: Only synchronize the cd2x update against the pipe's vblank
when the cdclk frequency is changing during the current
commit phase (Gustavo)
Cc: [email protected]
Cc: Gustavo Sousa <[email protected]>
Reviewed-by: Uma Shankar <[email protected]>
Signed-off-by: Ville Syrjälä <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]
(cherry picked from commit 34d127e)
Signed-off-by: Rodrigo Vivi <[email protected]>
0 commit comments