nvme: report write pointer for a full zone as zone start + zone len

The write pointer in NVMe ZNS is invalid for a zone in zone state full.
The same also holds true for ZAC/ZBC.

The current behavior for NVMe is to simply propagate the wp reported by
the drive, even for full zones. Since the wp is invalid for a full zone,
the wp reported by the drive may be any value.

The way that the sd_zbc driver handles a full zone is to always report
the wp as zone start + zone len, regardless of what the drive reported.
null_blk also follows this convention.

Do the same for NVMe, so that a BLKREPORTZONE ioctl reports the write
pointer for a full zone in a consistent way, regardless of the interface
of the underlying zoned block device.

blkzone report before patch:
start: 0x000040000, len 0x040000, cap 0x03e000, wptr 0xfffffffffffbfff8
reset:0 non-seq:0, zcond:14(fu) [type: 2(SEQ_WRITE_REQUIRED)]

blkzone report after patch:
start: 0x000040000, len 0x040000, cap 0x03e000, wptr 0x040000 reset:0
non-seq:0, zcond:14(fu) [type: 2(SEQ_WRITE_REQUIRED)]

Signed-off-by: Niklas Cassel <[email protected]>
Reviewed-by: Keith Busch <[email protected]>
Reviewed-by: Damien Le Moal <[email protected]>
Reviewed-by: Johannes Thumshirn <[email protected]>
Signed-off-by: Christoph Hellwig <[email protected]>

Author: Niklas Cassel

drivers/nvme/host/zns.c

@@ -166,7 +166,10 @@ static int nvme_zone_parse_entry(struct nvme_ns *ns,
 	zone.len = ns->zsze;
 	zone.capacity = nvme_lba_to_sect(ns, le64_to_cpu(entry->zcap));
 	zone.start = nvme_lba_to_sect(ns, le64_to_cpu(entry->zslba));
-	zone.wp = nvme_lba_to_sect(ns, le64_to_cpu(entry->wp));
+	if (zone.cond == BLK_ZONE_COND_FULL)
+		zone.wp = zone.start + zone.len;
+	else
+		zone.wp = nvme_lba_to_sect(ns, le64_to_cpu(entry->wp));
 
 	return cb(&zone, idx, data);
 }