ARM: configs: aspeed: Enable commonly used drivers

These devices are used by BMC platforms. Enable them so mainline
defconfigs can be used to test.

Signed-off-by: Joel Stanley <[email protected]>

Author: shenki

arch/arm/configs/aspeed_g5_defconfig

@@ -81,6 +81,7 @@ CONFIG_MTD_UBI_FASTMAP=y
 CONFIG_MTD_UBI_BLOCK=y
 CONFIG_BLK_DEV_LOOP=y
 CONFIG_EEPROM_AT24=y
+CONFIG_EEPROM_AT25=y
 CONFIG_NETDEVICES=y
 CONFIG_NETCONSOLE=y
 # CONFIG_NET_VENDOR_ALACRITECH is not set
@@ -141,6 +142,7 @@ CONFIG_SERIAL_8250_SHARE_IRQ=y
 CONFIG_SERIAL_8250_DW=y
 CONFIG_SERIAL_OF_PLATFORM=y
 CONFIG_ASPEED_KCS_IPMI_BMC=y
+CONFIG_IPMI_KCS_BMC_CDEV_IPMI=y
 CONFIG_IPMI_KCS_BMC_SERIO=y
 CONFIG_ASPEED_BT_IPMI_BMC=y
 CONFIG_HW_RANDOM_TIMERIOMEM=y
@@ -153,25 +155,33 @@ CONFIG_I2C_ASPEED=y
 CONFIG_I2C_FSI=y
 CONFIG_I2C_SLAVE=y
 CONFIG_SPI=y
+CONFIG_SPI_FSI=y
 CONFIG_GPIOLIB=y
 CONFIG_GPIO_SYSFS=y
 CONFIG_GPIO_ASPEED=y
 CONFIG_GPIO_ASPEED_SGPIO=y
+CONFIG_GPIO_PCA953X=y
+CONFIG_GPIO_PCA953X_IRQ=y
 CONFIG_W1=y
 CONFIG_W1_MASTER_GPIO=y
 CONFIG_W1_SLAVE_THERM=y
+CONFIG_SENSORS_ADT7475=y
 CONFIG_SENSORS_ASPEED=y
 CONFIG_SENSORS_IIO_HWMON=y
 CONFIG_SENSORS_LM75=y
 CONFIG_SENSORS_NCT7904=y
+CONFIG_SENSORS_OCC_P9_SBE=y
 CONFIG_PMBUS=y
 CONFIG_SENSORS_ADM1275=y
 CONFIG_SENSORS_IBM_CFFPS=y
 CONFIG_SENSORS_IR35221=y
+CONFIG_SENSORS_IR38064=y
+CONFIG_SENSORS_ISL68137=y
 CONFIG_SENSORS_LM25066=y
 CONFIG_SENSORS_MAX31785=y
 CONFIG_SENSORS_UCD9000=y
 CONFIG_SENSORS_UCD9200=y
+CONFIG_SENSORS_SBTSI=y
 CONFIG_SENSORS_TMP421=y
 CONFIG_SENSORS_W83773G=y
 CONFIG_WATCHDOG_SYSFS=y
@@ -232,7 +242,9 @@ CONFIG_RTC_DRV_ASPEED=y
 CONFIG_IIO=y
 CONFIG_ASPEED_ADC=y
 CONFIG_MAX1363=y
+CONFIG_SI7020=y
 CONFIG_BMP280=y
+CONFIG_DPS310=y
 CONFIG_RAS=y
 CONFIG_FSI=y
 CONFIG_FSI_MASTER_GPIO=y