riscv: dts: starfive: jh7110: Add PWM node and pins configuration

Add OpenCores PWM controller node and add PWM pins configuration
on VisionFive 2 board.

Signed-off-by: William Qiu <[email protected]>
Reviewed-by: Emil Renner Berthing <[email protected]>
Signed-off-by: Conor Dooley <[email protected]>

Author: littleqyp

arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi

@@ -323,6 +323,12 @@
 	};
 };
 
+&pwm {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pwm_pins>;
+	status = "okay";
+};
+
 &spi0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&spi0_pins>;
@@ -513,6 +519,22 @@
 		};
 	};
 
+	pwm_pins: pwm-0 {
+		pwm-pins {
+			pinmux = <GPIOMUX(46, GPOUT_SYS_PWM_CHANNEL0,
+					      GPOEN_SYS_PWM0_CHANNEL0,
+					      GPI_NONE)>,
+				 <GPIOMUX(59, GPOUT_SYS_PWM_CHANNEL1,
+					      GPOEN_SYS_PWM0_CHANNEL1,
+					      GPI_NONE)>;
+			bias-disable;
+			drive-strength = <12>;
+			input-disable;
+			input-schmitt-disable;
+			slew-rate = <0>;
+		};
+	};
+
 	spi0_pins: spi0-0 {
 		mosi-pins {
 			pinmux = <GPIOMUX(52, GPOUT_SYS_SPI0_TXD,

arch/riscv/boot/dts/starfive/jh7110.dtsi

@@ -829,6 +829,15 @@
 			status = "disabled";
 		};
 
+		pwm: pwm@120d0000 {
+			compatible = "starfive,jh7110-pwm", "opencores,pwm-v1";
+			reg = <0x0 0x120d0000 0x0 0x10000>;
+			clocks = <&syscrg JH7110_SYSCLK_PWM_APB>;
+			resets = <&syscrg JH7110_SYSRST_PWM_APB>;
+			#pwm-cells = <3>;
+			status = "disabled";
+		};
+
 		sfctemp: temperature-sensor@120e0000 {
 			compatible = "starfive,jh7110-temp";
 			reg = <0x0 0x120e0000 0x0 0x10000>;