scsi: storvsc: Increase the timeouts to storvsc_timeout

Currently storvsc_timeout is only used in storvsc_sdev_configure(), and
5s and 10s are used elsewhere. It turns out that rarely the 5s is not
enough on Azure, so let's use storvsc_timeout everywhere.

In case a timeout happens and storvsc_channel_init() returns an error,
close the VMBus channel so that any host-to-guest messages in the
channel's ringbuffer, which might come late, can be safely ignored.

Add a "const" to storvsc_timeout.

Cc: [email protected]
Signed-off-by: Dexuan Cui <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Reviewed-by: Long Li <[email protected]>
Signed-off-by: Martin K. Petersen <[email protected]>

Author: dcui

drivers/scsi/storvsc_drv.c

@@ -362,7 +362,7 @@ MODULE_PARM_DESC(ring_avail_percent_lowater,
 /*
  * Timeout in seconds for all devices managed by this driver.
  */
-static int storvsc_timeout = 180;
+static const int storvsc_timeout = 180;
 
 #if IS_ENABLED(CONFIG_SCSI_FC_ATTRS)
 static struct scsi_transport_template *fc_transport_template;
@@ -768,7 +768,7 @@ static void  handle_multichannel_storage(struct hv_device *device, int max_chns)
 		return;
 	}
 
-	t = wait_for_completion_timeout(&request->wait_event, 10*HZ);
+	t = wait_for_completion_timeout(&request->wait_event, storvsc_timeout * HZ);
 	if (t == 0) {
 		dev_err(dev, "Failed to create sub-channel: timed out\n");
 		return;
@@ -833,7 +833,7 @@ static int storvsc_execute_vstor_op(struct hv_device *device,
 	if (ret != 0)
 		return ret;
 
-	t = wait_for_completion_timeout(&request->wait_event, 5*HZ);
+	t = wait_for_completion_timeout(&request->wait_event, storvsc_timeout * HZ);
 	if (t == 0)
 		return -ETIMEDOUT;
 
@@ -1350,6 +1350,8 @@ static int storvsc_connect_to_vsp(struct hv_device *device, u32 ring_size,
 		return ret;
 
 	ret = storvsc_channel_init(device, is_fc);
+	if (ret)
+		vmbus_close(device->channel);
 
 	return ret;
 }
@@ -1668,7 +1670,7 @@ static int storvsc_host_reset_handler(struct scsi_cmnd *scmnd)
 	if (ret != 0)
 		return FAILED;
 
-	t = wait_for_completion_timeout(&request->wait_event, 5*HZ);
+	t = wait_for_completion_timeout(&request->wait_event, storvsc_timeout * HZ);
 	if (t == 0)
 		return TIMEOUT_ERROR;