ARM: dts: bcm2711: Fix xHCI power-domain

During s2idle tests on the Raspberry CM4 the VPU firmware always crashes
on xHCI power-domain resume:

root@raspberrypi:/sys/power# echo freeze > state
[   70.724347] xhci_suspend finished
[   70.727730] xhci_plat_suspend finished
[   70.755624] bcm2835-power bcm2835-power: Power grafx off
[   70.761127]  USB: Set power to 0

[   74.653040]  USB: Failed to set power to 1 (-110)

This seems to be caused because of the mixed usage of
raspberrypi-power and bcm2835-power at the same time. So avoid
the usage of the VPU firmware power-domain driver, which
prevents the VPU crash.

Fixes: 522c35e ("ARM: dts: bcm2711: Add BCM2711 xHCI support")
Link: raspberrypi/linux#6537
Signed-off-by: Stefan Wahren <[email protected]>
Link: https://lore.kernel.org/r/[email protected]
Signed-off-by: Florian Fainelli <[email protected]>

Author: lategoodbye

arch/arm/boot/dts/broadcom/bcm2711-rpi.dtsi

@@ -1,7 +1,6 @@
 // SPDX-License-Identifier: GPL-2.0
 #include "bcm2835-rpi.dtsi"
 
-#include <dt-bindings/power/raspberrypi-power.h>
 #include <dt-bindings/reset/raspberrypi,firmware-reset.h>
 
 / {
@@ -101,7 +100,3 @@
 &vchiq {
 	interrupts = <GIC_SPI 34 IRQ_TYPE_LEVEL_HIGH>;
 };
-
-&xhci {
-	power-domains = <&power RPI_POWER_DOMAIN_USB>;
-};

arch/arm/boot/dts/broadcom/bcm2711.dtsi

@@ -610,6 +610,7 @@
 			#address-cells = <1>;
 			#size-cells = <0>;
 			interrupts = <GIC_SPI 176 IRQ_TYPE_LEVEL_HIGH>;
+			power-domains = <&pm BCM2835_POWER_DOMAIN_USB>;
 			/* DWC2 and this IP block share the same USB PHY,
 			 * enabling both at the same time results in lockups.
 			 * So keep this node disabled and let the bootloader