Unable to install a sensor - mismatch in kernel modules #12949
-
Version2.4.60 Installation MethodSecurity Onion ISO image Descriptioninstallation Installation TypeDistributed Locationon-prem with Internet access Hardware SpecsExceeds minimum requirements CPU8 RAM32 Storage for /250Gb Storage for /nsm1Tb Network Traffic Collectionspan port Network Traffic Speeds1Gbps to 10Gbps StatusYes, all services on all nodes are running OK Salt StatusNo, there are no failures LogsNo, there are no additional clues DetailI have two grids, one using 2.3 and a new one using 2.4. On the 2.4 grid, the devices are all running 2.4.60, having been upgraded from 2.4.40. Here is the install log...
|
Beta Was this translation helpful? Give feedback.
Replies: 3 comments
-
When you run |
Beta Was this translation helpful? Give feedback.
-
This is from the manager: |
Beta Was this translation helpful? Give feedback.
-
I know its bad form to answer your own question, but here goes. |
Beta Was this translation helpful? Give feedback.
I know its bad form to answer your own question, but here goes.
We had this issue when the grid was at 2.4.60, and the "failing" setup was from a 2.4.40 iso install.
Yesterday we upgraded the grid to 2.4.70, and just for giggles I tried the setup again and it ran through and worked first time. Yah.
I can only presume that the combination of 2.4.60 and 2.4.40 was not happy, and 2.4.70 fixed it.