Get Started with SenseCAP Indicator | Seeed Studio Wiki

[giscus[bot]]

Get Started with SenseCAP Indicator | Seeed Studio Wiki

Get Started with SenseCAP Indicator

https://wiki.seeedstudio.com/Sensor/SenseCAP/SenseCAP_Indicator/Get_started_with_SenseCAP_Indicator/

[Mapperdave]

What is the Refresh Rate of the SenseCAP Indicator 4-inch?

[PaulSchulz]

Can you please confirm that the Grove connector Pin-Out shown is correct for both Grove Connecotrs? The GND/VCC pins are shown to be different (at opposite ends) between the two connectors.

As far as I can tell, Grove(IIC) is correct,, and the Grove(ABC) has been mirrored in the above documentation.

[Jessie219-web]

thanks for your feedback, we will check it asap

[david9600]

I noticed this too (while figuring out how to attach a 3-wire temp/humidity sensor).
A voltmeter tells me that the outline of the ADC connector is rotated 180 degrees. The IIC connector is shown correctly.

[danuw]

Hi, I was wondering: Is there anyway to get the HA firmware in a format that can be dropped (without needing to build it locally?) - not sure I saw in the instruction that anything needed to be customised before being built and flashed apart from config in HA please?

[Zeke5579]

You may first need to design the HA features you need yourself and then flash the firmware. You can refer to the following article:https://wiki.seeedstudio.com/sensecap_indicator_project/#2-squareline-studio

https://www.hackster.io/spenyan/low-code-ui-design-for-sensecap-indicator-with-squareline-9825fe