T1000-E Tracker Introduction | Seeed Studio Wiki

[giscus[bot]]

T1000-E Tracker Introduction | Seeed Studio Wiki

SenseCAP Card Tracker T1000-E for Meshtastic Introduction

https://wiki.seeedstudio.com/t1000_e_intro/

[bontrager-dev]

Which LoRa frequency is the antenna optimized for?

[zander13auto]

I want to make a solar charger for the tracker 1000e that uses the magnetic charging interface and wanted to know if there is a part number for the charging cord side of the connector or if you sell just that (not molded into a cord) I found something very close on Amazon that does snap on and has all the pins in the right place, but the pins don't protrude enough as they do on the charging cord that comes with it and so they do not make a connection to charge. Thanks for any help or guidance...

[tonyleo723]

You can purchase a charging cable for the T1000-E from the link below:

https://www.seeedstudio.com/USB-Cable-Type-A-to-4P-with-magnetic-type-Black-1000mm-p-5977.html

Maybe you can buy one, cut off the USB-A connector, and test the connectivity of the cable with a multimeter. The pin definitions for each magnetic contact you can see in the wiki above.

[Rodrigo2m]

I want a firmware for LoRaWAN, firmware of sense app

[Kian-kang]

https://wiki.seeedstudio.com/open_source_lorawan/

[alexl83]

I'd like to use e-lux sensor with meshatstic's "detection sensor module" e.g. when light is detected an alert is triggered
Can you advise how to configure it?

The same I'd like to achieve with accelerometer; when movement is detected an alert is triggered