LoRaWAN Sensor Node | Seeed Studio Wiki #1933
giscus[bot]
bot
Replies: 5 comments 9 replies
-
|
Hi , in the above example code how to switch Class A & Class C devices and Downlink source code is not available |
Beta Was this translation helpful? Give feedback.
-
|
Hi , in the above example code how to switch Class A & Class C devices and Downlink source code is not available |
Beta Was this translation helpful? Give feedback.
-
|
Sorry for the late reply. Regarding the first question, it is recommended that you refer to the GitHub of Radiolib and adjust the code to configure it as the corresponding Class A or C. As for the second question, could you please provide me with more information? We have verified that it works, which will facilitate me to provide technical support. |
Beta Was this translation helpful? Give feedback.
-
|
Refer to this example from RadioLib: |
Beta Was this translation helpful? Give feedback.
-
|
Would be nice to see a deep sleeping sample code. |
Beta Was this translation helpful? Give feedback.
-
|
We not sure how you use it, but you can refer here to try low power sleep mode: https://github.com/Lora-net & |
Beta Was this translation helpful? Give feedback.
-
|
The arduino code isnt working on my node but i can not find firmware files to edit and upload manually for lorawan sensor node operation. Also why does xaio esp32 s3 come advertised as lorawan but then have firmware flashed for meshtastic? |
Beta Was this translation helpful? Give feedback.
-
|
What code you are using? And what is not working? Can you post the code and the error messages? |
Beta Was this translation helpful? Give feedback.
-
|
I was able to find the proper firmware but don't exactly how to see if this was all done properly. I don't see anything coming up on the screen on the breakout board, but in terminal i get so obviously seems like an error since it doesn't see a gateway matching its config. Is there a way to see if this is set up properly so i can set up a gateway with a known good edge sensor? Is there a way to read sensor data via serial? |
Beta Was this translation helpful? Give feedback.
-
|
I think it is more a configuration problem. (https://jgromes.github.io/RadioLib/group__status__codes.html) I'm using the XIAO S3 device with a CO2-sensor and it is working fine with TTN (and also with local ChirpStack server). BTW: Serial output (USB terminal) is working fine in my case. |
Beta Was this translation helpful? Give feedback.
-
|
Hi Team, I'm trying to connect the kit to TTN but it can't able to connect to the WiFi, this is the response I'm getting from the kit. I (299) esp_image: segment 4: paddr=00118bb8 vaddr=4037bbI (4799) wifi:state: run -> init (f00) |
Beta Was this translation helpful? Give feedback.
-
|
make sure you have connected the wifi antenna, and your wifi should be 2.4GHz |
Beta Was this translation helpful? Give feedback.
-
|
Would have liked a working example where, since you are using for implementation inside TTN, the base code followed the fair use policy. The code also cannot handle the node restarting without removing and readding the device inside the console due to DevNonce errors, otherwise very helpful. |
Beta Was this translation helpful? Give feedback.
-
|
we will consider adding this example later. thanks for your feedback. |
Beta Was this translation helpful? Give feedback.
Uh oh!
There was an error while loading. Please reload this page.
-
LoRaWAN Sensor Node | Seeed Studio Wiki
Lorawan sensor node based on Wio SX1262 with XIAO esp32s3 module
https://wiki.seeedstudio.com/wio_sx1262_xiao_esp32s3_for_lora_sensor_node/
Beta Was this translation helpful? Give feedback.
All reactions