Getting Started with Meshtastic® Kit | Seeed Studio Wiki

[giscus[bot]]

Getting Started with Meshtastic® Kit | Seeed Studio Wiki

Get Started with Wio Tracker Dev Kit for Meshtastic®

https://wiki.seeedstudio.com/meshtastic_kit_wio_tracker_1110/

[eerke2021]

Which Pin is the GPS connected to?

[eerke2021]

Using the Grove GPS, not the onboard gos connector.

[Jessie219-web]

Grove GPS is connected to the UART port
RXD: P0.24
TXD: P0.25
3V3
GND

[eerke2021]

Thanks. I’ve updated the settings in Meshtastic. On 18 Dec 2024, at 02:07, Jessie ***@***.***> wrote: Grove GPS is connected to the UART port RXD: P0.24 TXD: P0.25 3V3 GND —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you commented.Message ID: ***@***.***>

[StrangePelaton]

I only get NaN for both temp and humidity. Is there something besides telemetry that I need to set up?

[Jessie219-web]

did you enable the sensor? navigate to Meshtastic App: Settings-> Telemetry(Sensors) -> Enable sensors.

[StrangePelaton]

Yes, everything was enabled. It shows telemetry coming from the Wio Tracker 1110 Dev Kit in the node list when i am connected to my other node, meaning the telemetry is working, but what it transmits is simply "NaN" for all fields. I used the official meshtastic web flasher correct firmware for the board, and have tried several recent and current versions of the app. I get telemetry with accurate numbers from every other node except the Wio Tracker 1110 Dev Kit. On Monday, June 23, 2025 at 05:16:12 AM EDT, Jessie ***@***.***> wrote: did you enable the sensor? navigate to Meshtastic App: Settings-> Telemetry(Sensors) -> Enable sensors. — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you commented.Message ID: ***@***.***>