RX_Demo using 315Mhz ASK/OOK door bell as a test #57
Description
Hello, I have taken the new WiringPi that now being supported again and built it on a Raspberry Pi Zero 2 W. I have built the RX_Demo and TX_Demo code and have it working just fine between two Pi's.
When I take the RX_Demo program and setup to capture 315Mhz ASK/OOK signal I cannot capture any signals.
I setup my debugger and it appears that the "if (cc1100.packet_available())" is not being able to detect a new packet.
I have also ran the RX_Demo and TX_Demo programs and can debug the RX_Demo program and the debugger can detect a packet being received.
Any suggestions on what could be preventing the packet from being detected would be greatly appreciated.
Cheers
Joe