Can I remove and re add biomes to override them

[Danjhop4]

Planning to replace cave biomes and possable wilder wild but my datapack uses diffrent values then vanilla

[gniftygnome]

If you are talking about noise biomes (vanilla and datapack; sometimes modded) then yes, removals (https://github.com/TerraformersMC/Biolith/wiki/Multi%E2%80%90Noise-Placement#remove-biomes) remove noise biomes and additions (https://github.com/TerraformersMC/Biolith/wiki/Multi%E2%80%90Noise-Placement#add-biomes) add noise biomes. Removals are processed prior to all Biolith methods of adding or replacing biomes, including additions.

If you want to remove biomes which are added by TerraBlender, in most cases you need to replace them with another biome instead of removing them. If you want to remove biomes which are added by Biolith itself, you need to use a higher-level method to replace them (so, use the replacement system if the biome was an addition; use the sub-biome system if the biome was a replacement, and you cannot remove sub-biomes).

[Danjhop4]

@gniftygnome was going to do remove then add biome

[Danjhop4]

@gniftygnome a simple remove and readd is plan given data packs are not normally mod compatible

[gniftygnome]

Biolith is fully data-pack compatible; if a data pack is used f.e. to replace the entire Overworld noise and biome selection, you can still remove, add, replace, etc. the biomes with Biolith.

In case it wasn't clear above, if you are removing and adding a vanilla biome, it will work just fine. You might want to test it with a TerraBlender mod installed also (BOP, RU, etc.) so you can see if it is working as desired in that situation.

[Danjhop4]

@gniftygnome yeah sounds about right I was not sure could remove and add biomes without them conflicting

[Danjhop4]

@gniftygnome only counting Biolith as of now as a few mods change biomes