Is there a way to recover from KTC error state? #53
Unanswered
kingjamez
asked this question in
Configuring
Replies: 1 comment
-
|
Never mind, I discovered that restarting klipper (not firmware) works for this. |
Beta Was this translation helpful? Give feedback.
0 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Uh oh!
There was an error while loading. Please reload this page.
-
I'm having problems with my Jubilee not picking up my tool. When I run tool_lock and it goes through it's 3rd iteration, it will often put KTC into an error state. This is seemingly unrecoverable and requires me to reboot the entire PI. Is there a way to flush that and start over cleanly?
Beta Was this translation helpful? Give feedback.
All reactions