IDEX printer with ERCF

[mg1975-hub]

Upon first glance this seems like its what i need, but am having a difficult time getting it to work. Initially have the printer setup with IDEX (extruder, extruder1). Now im trying to add the ERCF to T0 (extruder). I do not have a physical toolchanger. I'm gettting the "Unknown tool is active and can't be deselected" error when selecting any of the tools. Ive tried the set_all_tools_deactive without any luck. Ive attached the configs and logs if anyone can point me in the correct direction. Thanks ahead for any help
logs-20250902-182651.zip
config-20250902-182545.zip

[TypQxQ]

I'll have a look probably tomorow.
Issueing a deselect all command should have worked.

[TypQxQ]

I looked at what you sent me and I can't find that you disengage the tools.
Just use KTC_TOOLCHANGER_DISENGAGE as described in the command refference and it should work after that.

[mg1975-hub]

Thank you. I’ll make that change and see if I can get it working.On Sep 9, 2025, at 3:41 PM, Andrei Ignat ***@***.***> wrote: I looked at what you sent me and I can't find that you disengage the tools. Just use KTC_TOOLCHANGER_DISENGAGE as described in the command refference and it should work after that. —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you authored the thread.Message ID: ***@***.***>

[mg1975-hub]

Still no luck. I've tried adding that to different areas and tried executing it from console first, still not able to pick between T0 and T1.