Cover Position control

[FLAI16]

Hi,

I use HA to control and visualize my KNX system. The following problem occurs. I have 4 blinds with angle adjustment. For two of the four blinds, I can use the slider in HA to move from 0% to 100% or vice versa. An intermediate position, e.g., 60%, can only be reached once the angle has been opened or closed, depending on the direction of travel. For the other two blinds, the height position can only be controlled with the slider if the angle has been adjusted beforehand. What could be causing this? I have set up the blinds identically in HA and KNX. Thank you very much for your help and support.

I use the MDT blind/blind actuator

Best regards,
Florian

[farmio]

Hi 👋!
This is probably some configuration issue. Check your GA assignments in your HA config and their assigned objects in ETS. Also check the channels config in ETS.
You can observe what HA does when you change sliders etc. if you look at a knx group monitor.

[FLAI16]

Thanks for the quick reply.
The settings and assignments in HA and KNX are correct. When I use the slider, I can see the adjusted values in the group monitor, both in HA and KNX, but the actuator does not seem to receive these values.

[farmio]

This seems to be a problem of the actuator (or couplers, if involved) then.