Will a LORA RYLR998 fit inside the case?

[D0T-C0M]

My apologies if this is not the right spot to ask a question but I've been looking for something very compact and this case is awesome for my project. With the recommended battery 7mm x 18mm x 50mm, can I fit a RYLR998 LORA module inside or use a smaller battery? I want to make a remote start for my UTV vehicle.

[lewisxhe]

The largest size that can be placed is 47257mm.

[D0T-C0M]

thx, I was able fit the RYLR998 LoRa module inside but this is only a prototype, but its not professional, I really need to get my own 3d printer :) Is there a place where I can have the orange piece that snaps in the back with the magnet glued on replaced with a new printed piece that I could mount the RYLR998 in and plug directly into the pin headers on the lilygo-s3 board. The RYLR is very mallI would need fifty to hundred of these enclosures. The RYLR998 Is very small and it uses only 4 pins, 3.3v, GND, GPIO18 and GPIO17 so it could be very small .