Chinese Digital Calipers 150mm

[Gujustud]

Call me silly, but I can't seem to figure out what to use to mount this part? My brain says it should have 2 steps coming out the sides instead?

Centerpieces/Tool_hooks/1x3 Chinese Digital Calipers 150mm.stl

Ignore, I finally figured out that 10x8 pins are needed!

[kusold]

Thanks for posting the solution, I came here with the same problem.

After learning about pins, I saw this in the README:

Some centerpieces do not have tabs on the model to press into the sidepiece, such as the "Spacer clip-on" centerpieces used in this recipe. This is always a result of avoiding "supports" in the print job. Print out a set of these 4 pins, press-fit on either side of the "Spacer clip-on" part, then press into the left/right sidepieces along with the Locking Spacer.