First testing of FSK Packet Decoding

[GMW1988]

All the LEDs light up appropriately. I am able to get the SW signal sent.

However, the first transmission test of FSK from step 1 on new board is not getting decoded on the Ground Station.
A transmission is being made. I can see the signal being picked up that in the FSK format. I looks like a good signal coming in. I hear rumbling sound on the radio. However, I am not able to get the Ground Station to decode any FSK information. It goes into simulation mode. Possibly there was something I overlooked with my soldering work.

[alanbjohnston]

The RF signal looks good in FoxTelem, so I don’t think it is a hardware issue. You need to click the Start button for it to start decoding.

Do you see the Frames and Payloads count at the bottom of FoxTelem increase?

if not, try BPSK mode by pressing and holding the pushbutton until it blinks 3 times then quickly releasing. The RF signal will go away then come back looking different in about 30 seconds. You need to change FoxTelem to BPSK 1200 Fox-1E mode by clicking Stop then selecting that option under Telem Format. Then click Start.

See if you see the Frames and Payloads count counts increasing.

Alan

[GMW1988]

Thank You. Yes, I see the Frames and Payloads count is increasing.

So it looks good so far.