Calibration test for fast LCDs

[rezjat]

Hi. As new mono LCDs are being common in LCD 3D printing, as Elegoo Saturn, would it be possible to get test codes for much lower exposure times between 1 and 4 seconds)?

[X3msnake]

makes no sense to use this on a mono. besides wuntill chitu allows per layer exposure this is useless Just search on thingiverse Validation Matrix and use it to calibrate your resin. LCD resins on Mono screens are always between 1.2s and 4s, and SLA/DLP resins between 12 and 18s rezjat <notifications@github.com> escreveu no dia terça, 12/01/2021 à(s) 16:46:

…

Hi. As new mono LCDs are being common in LCD 3D printing, as Elegoo Saturn, would it be possible to get test codes for much lower exposure times between 1 and 4 seconds)? — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#26>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ACUR56RDLAQ6NW2CNU7NZI3SZR4G7ANCNFSM4V7PQJTA> .

-- Com os melhores cumprimentos, Vinicius Silva

[rezjat]

Thanks for feedback. But I do not understand why it has no sense... It has the same sense to find the right exposure, only difference being the exposure steps.

I just found a "Multiprinter - Resin Exposure Test V2" that solves the issue, providing this same tests for monochrome printers.
Thanks

[X3msnake]

Makes no sense because you need per layer exposure otherwise the results are not correct and will give false positives that is why XP2 is still a beta test since it is not reliable and repeatable. Slicing the Validation Matrix and using it as a direct test is fast enough on a mono to do it a couple of times at different exposure times and get the calibration fast rezjat <notifications@github.com> escreveu no dia terça, 12/01/2021 à(s) 20:52:

…

Thanks for feedback. But I do not understand why it has no sense... It has the same sense to find the right exposure, only difference being the exposure steps. I just found a "Multiprinter - Resin Exposure Test V2" that solves the issue, providing this same tests for monochrome printers. Thanks — You are receiving this because you commented. Reply to this email directly, view it on GitHub <#26 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ACUR56R22JQO6D64A7XFXD3SZSZCXANCNFSM4V7PQJTA> .

-- Com os melhores cumprimentos, Vinicius Silva

[rezjat]

Ok, thanks for your explanation!