EnergyTotal 0

[dippes]

Hello,

I performed an “EnergyTotal 0” to reset the old consumption values to zero. Now everything is at zero, but voltage, amperage, and current consumption are no longer displayed.

How can I turn this back on?

[sfromis]

By default, the measurements of voltage and current are only displayed while power is on. EnergyTotal resets the at-midnight values, but not pending EnergyToday.

[dippes]

I reset my Gosound P1 and set it up again.

But the power indicator isn't showing anything anymore, even when a device is turned on.

` Analog0 1024

Spannung 0 V
Strom 0,000 A
Wirkleistung 0 W
Scheinleistung 0 VA
Blindleistung 0 var
Leistungsfaktor 0,00
Energie heute 0,000 kWh
Energie gestern 0,000 kWh
Energie gesamt 0,000 kWh`

[sfromis]

Maybe that "set it up again" was not with a correct config. You may also have to calibrate again.

[dippes]

I used this template for setup: {"NAME":"Gosund P1","GPIO":[0,3072,544,3104,0,259,0,0,225,226,224,0,35,4704],"FLAG":0,"BASE":18}

I also calibrated it.

What else can I check?

[dippes]

I ordered a new Gosound P1 power strip which was preconfigured with Tasmota.

The configuration is the same as my old one where the voltage display does not work.

Could the current sensor be defective? If so, how can I find that out?

[dippes]

I reset the device again (reset 1-6)

and reconfigured it, then performed a power monitoring calibration.

I also restored the backup from the working device, but no data is being displayed.

Question: Would flashing the firmware again via the serial interface help?