Is it normal to encounter "failed" when processing the dataset?

[charlotte0104]

just as shown at the picture, if it's normal to encounter failure

[SanazKaz]

Hi Charlotte, I also encountered this error. I don't have a fix currently.

[zhaozhongyan-822]

Hi Charlotte, I also encountered this error. I don't have a fix currently.

Hi, SanazKaz, I am also encountering this issue now. Do you have any good solutions? If you have resolved it, could you share and guide me? I would be very grateful for your response~

[zhaozhongyan-822]

just as shown at the picture, if it's normal to encounter failure

Hi, charlotter, I am also encountering this issue now. Do you have any good solutions? If you have resolved it, could you share and guide me? I would be very grateful for your response~

[WJmodels]

At the beginning, I encountered the same problem. I was originally using the built-in decompression software to extract the compressed data, but later, when I decompressed it using code (tar -xzvf crossdocked_pocket10.tar.gz), the error did not occur.

[zhaozhongyan-822]

At the beginning, I encountered the same problem. I was originally using the built-in decompression software to extract the compressed data, but later, when I decompressed it using code (tar -xzvf crossdocked_pocket10.tar.gz), the error did not occur.

Think U! I might have had some issues with the version before. Although I still have a lot of doubts to be resolved, I can run it normally after setting up the virtual environment again.

[shy922]

At the beginning, I encountered the same problem. I was originally using the built-in decompression software to extract the compressed data, but later, when I decompressed it using code (tar -xzvf crossdocked_pocket10.tar.gz), the error did not occur.

Could you share the decompressed dataset? I don't have a Linux system？Thank you！